How To Use; Preparation For Operation - Shizuoka Seiki Co. VAL6 EPX Manuel D'utilisation

Chauffage infrarouge au fioul
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

How to use

3

3-1. Preparation for operation

• Never use highly fl ammable fuel like gasoline, to avoid fi re.
• Never contaminate or mix fuels. For example, never contaminate kerosene with gasoline by using a gasoline container to
carry kerosene. Even a small amount of gasoline, or other volatile fuels, in kerosene is hazardous. Store kerosene only in
containers specifi cally labeled and approved for kerosene and do not use the container for any other fuels or chemicals.
• Please refuel only while the heater is turned off and completely extinguished.
• Use only the electric power (voltage and frequency) specifi ed on the model plate of the heater to operate the heater. Using
electrical power different from the specifi cations may result in fi re, electrical shock, and/or damage.
• Please confi rm the ground/earth cable is properly connected, to prevent electrical shock.
• When disconnecting the electric power cord, be sure to always pull the plug out by itself. Do not pull out the plug by pull-
ing on the power cord. Also, do not allow or cause excessive force to be exerted on the cord at any time to avoid damaging
it and causing a fi re or shock hazard. The heater should not be operated with the power cord in a taut or tightened position
to further avoid damage to the cord, accidental unplugging of the electricity, and fi re and/or shock.
■ Refueling
• Please use "kerosene" or "Fuel-Oil no heavier than No.2 (Diesel)" and do not use poor quality or foul fuel, to help avoid
ignition, operating, and other problems.
1
Remove the fuel cap and insert a suction
pump into the fuel tank.
Watch the fuel gauge while refueling.
2
When the gauge reaches the maximum level,
stop refueling.
■ Adjust the angle of the main unit
• Do not adjust the angle of the main unit while the heater is plugged in, operating, or hot to avoid severe burns and electric shock.
Prior to operation, loosen the knob bolt to
move and set the main heater unit at the de-
sired angle, and tighten the knob bolt fi rmly.
The vertical angle of the radiation disk is ad-
justable up to 15 degrees.
9
DANGER
CAUTION
Observations
Wipe off any fuel that has spilled onto the
3
fuel tank or elsewhere. Replace the fuel cap
and tighten it securely. Do not operate the
heater with a loose fuel cap or without a fuel
cap.
CAUTION
Tighten
Loosen
15 degrees

Publicité

Table des Matières
loading

Table des Matières