How To Connect The Control Device; Use Of The Heat Shielding Mat; Inspection - Shizuoka Seiki Co. Hot Gun 125NA Manuel D'utilisation

• Make sure that the blower fan has stopped running before unplugging the power plug from the AC outlet. Failure to do
so can result in damage.
• Never disconnect the power plug while the heater is operating, it will cause nozzle to be clogged.
Turn "OFF" the operating switch.
After the flame is extinguished, the blower
fan will automatically stop running after
about three (3) minutes and finally the op-
eration lamp will turn off.

3-3. How to connect the Control device

To connect the control device
Uncouple the terminals (A) attached to the
1
tip of white wires that come out of the burner base.
Connect both male and female terminals,
2
which are uncoupled, to the connectors (B) of
control device.

3-4. Use of the Heat Shielding Mat

To avoid unexpected fire or trouble, NEVER
use the heater on combustible flooring un-
less the heat shielding mat, which is avail-
able as an option, is used.

Inspection

4
CAUTION
• Please do not pour in the fuel tank the fuel used for cleaning the tank inlet filter ; after you finish to inspect inside the
fuel tank, please do not return back into the fuel tank foul fuel taken out of the tank.
Observations
• Before starting any inspection or service, to avoid electric shock, please make sure the
heater is shut down and that the power cord is disconnected.
• When cleaning the heater, please wear gloves to prevent possible injury.
• Make sure that the heater has cooled down. The hot air outlet is hot just after the heater
is shut down. Touching the outlet at this time will result in burns.
Observations
Operating switch "OFF"
O F F
R U N
O N
N
O P T IO
Observations
• When the heater is controlled by another device (such
as a thermostat or a timer), the heater could turn itself
on at any time.
Terminals (A)
To Control Device
Heat shielding mat
E
M IS F IR
Operating lamp off
Connectors (B)
11