Shizuoka Seiki Co. VAL6 EPX Manuel D'utilisation page 20

Troubleshooting
6
■ When you face problems with your heater, please refer to this check-
list before consulting with your dealer.
In case satisfactory results do not result by referring to the table, or you have problems not described in this
table, please contact your dealer. While consulting with him, please describe the problem you have, together
with model name and serial number of your heater.
Phenomenon
The heater does not start.
(The lamp does not light
up.)
The heater does not start.
(The lamp is lit.)
The heater does not ignite.
The fl ame goes out during
the operation.
If the following phenomenon takes place, it is usually not a sign of trouble. Please check
again before consulting with your dealer.
Phenomenon
When used for the fi rst time, smoke or smell
comes out of the heater.
At the time of ignition or shut-down of the
heater, noise comes from the burner section.
Exchange procedures
7
• Never service the heater while it is burning, in operation, hot or plugged-in to avoid any injury and/or trouble.
• Before starting any service, to avoid electric shock, please make sure the heater is shut down and that the power cord is
disconnected.
• When servicing the heater, please wear gloves to prevent possible injury.
17
Possible Cause
Power cord is not connected with an
AC outlet. Power supply is cut off.
Blown fuse
Safety devices are working.
No fuel in the fuel tank.
There is water in the fuel tank.
Fuel fi lter element is clogged.
Nozzle is clogged
Wrong or foul fuel is used.
Flame monitor is dirty.
Fuel fi lter element is clogged.
Because fuel is burning together with dusts, etc. This phenomenon will disap-
pear after a short while.
Noise is caused by expansion or shrinkage of the burner section due to
temperature's up and down. This is not irregular.
WARNING
CAUTION
Remedy
Please connect the power cord with an AC outlet, and
check the power supply.
Replace fuse with a new one.
Please refer to page 7 and solve the problems, or
consult with your dearler.
Please pour fuel into the tank.
Please clean up the tank and fi ll it with fresh/clean fuel.
Check the fi lter element and replace it with a new one.
Replace nozzle with a new one.
Please clean up the fuel tank and fi ll it with fresh/new
fuel.
Please clean up the Flame Monitor
(Please refer to page 15).
Please check the fi lter element and replace it with a
new one.
Explanation
(Please refer to page 18.)
(Please refer to page 18.)