brennenstuhl AL 1000 Mode D'emploi page 9

Mobile LED Spotlight AL
The motion detector can be rotated horizontally right and left as well as vertically up and down.
When attaching the spotlight, make sure that the motion detector reacts most sensitively to
movements that run across the detection field and least to movements directly toward the device.
ADJUST MOTION DETECTOR
Rotate the mounted spotlight upward. You will see three controls on the bottom of the motion
detector (Fig. 9).
SENSITIVITY (SENS, MIDDLE): (Fig. 10)
The sensitivity determines the maximum distance at which the sensor switches on due to a per-
son's movements
LIGHT SETTING (LUX, RIGHT): (Fig. 10)
The light setting determines the brightness at which the spotlight's sensor switches on. The
position (sun symbol - right) shows that the sensor works during the day and at night, in the other
position (moon symbol - left), the sensor works only at night.
To set, wait until the desired brightness is reached in the surroundings. Set the time sensor TIME
to the minimum time (10 sec.). Turn the light setting control completely to the symbol (moon).
Turn the control slowly toward the symbol (sun) until the spotlight switches on from movement.
The sensor will not switch on when detecting a motion beginning with the set brightness.
TIME SETTING (TIME, LEFT): (Fig. 10)
With this control, you can select any switch-on time between approx. 10 seconds and 4 minutes
after the last movement has been detected. Turning the TIME control in the clockwise direction
increases the time period, and reduces it in the anti-clockwise direction.
MOTION DETECTOR: PASSIVE INFRARED SENSOR
Detection range: up to 12 m / up to 180° (horizontal)
Time setting: approx. 10 sec. to 4 min.
CONFORMITY
The conformity is stored at the manufacturer.
9