Jenn-Air JMW2427IL Mode D'emploi page 12

FOR SERVICE TECHNICIAN'S USE ONLY
15. Plug in oven or reconnect power.
16. Verify operation is normal. Enter the Diagnostics menu, select "Error
Diagnostics," and clear the history.
FAILURE ERROR
E0
F2
Keypad
E1
SUGGESTED CORRECTIVE ACTION PROCEDURE
NOTE: Before starting any test, cycle power to the oven (power off, wait 10
seconds, and power on).
PROCEDURE: Before proceeding, verify the error code by entering the
Diagnostics mode and selecting "Error Diagnostics."
1.
Unplug oven or disconnect power.
2. Check that connectors J4, J5, J6, and J7 are firmly connected. If they are
not, go to Step 3. If they are, go to Step 6.
Speaker
HMI Left
J6
3.
Reconnect any loose connectors.
4. Reassemble all parts and panels before operating.
5. Plug in oven or reconnect power. If the failure is gone, go to Step 9. If the
failure is still present, unplug oven or disconnect power.
6. Replace the Control Panel Assembly.
7. Reassemble all parts and panels before operating.
8. Follow the on-screen prompts to select the model number.
9.
Verify operation is normal. Enter the Diagnostics menu, select "Error
Diagnostics," and clear the history. If the Control Panel Assembly was
replaced, there is no need to clear the error history.
12
LIKELY FAILURE CONDITION
Keypad disconnected
Stuck/Shorted keypad
BK
J8
RD
User Interface
HMI Right
J4 J5 J7
J15
Control Panel Assembly
1 2 3 4