GoodHome Solna Mode D'emploi page 16

. .
. .
Use
. .
. .
. .
.
Setting the ECO mode temperature
The Comfort and ECO setpoint temperatures are
set separately.
The ECO mode temperature range is between 13 °C
and 29.5 °C and can be adjusted in increments of
0.5 °C. If limited, increase the Comfort temperature,
as the ECO temperature is always lower than the
Comfort temperature.
• When ECO mode (Eco) is in operation, press the
+ or - button to increase or reduce the setpoint
temperature. The temperature flashes.
• Press the button to cancel the setting,
or the OK-boost button to validate the ECO
temperature selected.
Setting the Boost
The temperature setting is automatically forced
to 30 °C during boost. When Boost finishes, the
thermostat returns to the mode and temperature
that was previously set.
• Press and hold for 3 seconds on the OK-boost
button to switch Boost on or off.
• (Only for an appliance with a blower): Press
the + or - button to select bSt (Boost without
blower) or FAn (Boost with blower), then press
the OK-boost button to validate.
• Press the + or - button to select the Boost time:
5, 10, 15, 20, 30, 45, 60, 90 or 120 minutes (the
default selection is 60 minutes without blower
and 15 minutes with blower), then press the
OK-boost button to validate the selection; the
remaining time in Boost is displayed.
• Press the MENU button to stop the Boost.
Only for an appliance with a blower: the fan
continues to run for a few seconds after stopping
the Boost to cool the blower.
In Programme mode, Boost can be stopped at any
time by pressing and holding for 3 seconds on the
OK-boost. Following a manual stop in
Programme mode, Boost can only be reactivated by
a programme after a period of 2 hours.
Precautions for use
Setting the temperature
• The heating power is maximal as long as the
setpoint temperature has not been reached.
Programming the setpoint temperature to the
maximum temperature possible, will not heat the
room quicker.
• Wait several hours for the room temperature
to stabilise before adjusting the temperature
setting.
• Shut down the appliance when ventilating the
room.
Maintenance (only for an appliance with a
blower)
IMPORTANT: Do not operate the blower
without its air filter.
• Regularly clean the air inlet and outlet vents as
soon as they begin to clog.
16