Water Connection - Black & Decker BPD8W Manuel D'instructions

SET UP & USE

WATER CONNECTION

Your dishwasher comes equipped with a 'quick connect' assembly (includes inlet
and drain hose). The faucet adapter must be installed on the faucet before you can
connect the dishwasher. This adapter is included inside your dishwasher. The faucet
adapter is compatible with faucets inclusive of either male (outside) or female (inside)
threaded faucet connections.
Rear of Dishwasher
WARNING: In order to avoid that there is more water staying in the inlet hose,
please close the faucet after using.
1. Screw the faucet adapter onto (or into) the faucet tap. Check for leaks (use Teflon
tape to eliminate if necessary).
2. Connect the six-sided connection of the drain hose to the drain port connection
on the back of the dishwasher cabinet. Do not over-tighten (to avoid damage to
threads).
3. Connect the star-shaped connection of the inlet hose to the inlet port on the back
of the dishwasher cabinet. Do not over-tighten (to avoid damage to threads).
4. Connect the circular connection of the drain hose onto the longer (bottom) male
connection on the quick connect.
5. Connect the circular connection of the inlet hose onto the shorter (top) male
connection on the quick connect.
6. Attach the quick connect onto the faucet adapter, by pulling down the outer
locking collar on the quick connect, while pushing the quick connect upward onto
the faucet adapter.
Faucet
Adapter
Drain Port
Connection
Inlet House
Connection
Drain House
Connection
Inlet Port
Drain Outlet
Collar 7. When the quick connect snaps onto the faucet
adapter, release the locking collar. Verify the
connection is secure.
8. Slowly open the hot water line and check for
any sign of water leaks at all hose connections.
If leaks are located, immediately close the water
supply and repair the hose connections.
Inlet Connection
Faucet
Adapter
Pressure
Relief
Button
(red)
Quick
Connect
Page 9