Change The Program; At The End Of The Wash Cycle - Black & Decker BPD8W Manuel D'instructions

SET UP & USE

CHANGE THE PROGRAM

You can modify the washing program, when the dishwasher just runs for a short time.
Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water. If this is the case, the detergent dispenser must
be refilled (see the section entitled "Loading the Detergent").
To change the washing program, press the program button more than three seconds
the machine will be in stand by state, then you can change the program to the
desired cycle setting (see the section entitled "Starting a wash cycle")
NOTE: If you open the door when washing, the machine will pause. When you close
the door, you need press start/pause button to keep the machine working.
FORGOT TO ADD A DISH
A forgotten dish can be added any time before the detergent dispenser opens.
1. Press the start/pause button.
2. Open the door slightly to stop the wash cycle.
3. After the spray arms stop working,you can open the door completely.
4. Add forgotten dishes.
5. Close the door.
6. Press the start/pause button, the dishwasher will run after 10 seconds.

AT THE END OF THE WASH CYCLE

When the working cycle has finished, the buzzer of dishwasher will sound 8 seconds,
then stop. Turn off the appliance using the ON/OFF button, shut off the water supply
and open the door of the dishwasher. Wait a few minutes before unloading the
dishwasher to avoid handling the dishes and utensils while they are still hot and more
susceptible to breakage. They will also dry better. Since the appliance is standing by,
it will power off automatically after 30 minutes without any operation.
Switch Off the Dishwasher
All the phase lights are off, only in this case, the program has ended.
1. Switch off the dishwasher by pressing the ON/OFF button.
2. Turn off the water tap!
3. Allow time for your dishes to dry before opening the door.
Condensing Drying Method Your dishwasher uses a non-vented drying method. After
the final rinse the water is pumped out and the unit shuts off. The remaining water on
the hot dishes will eventually evaporate, condense and run off into the bottom of the
unit. To ensure that your dishes dry well, it is highly recommended that a rinse aid be
used. Be advised that items such as cups and glasses, which have a concave bottom,
may retain droplets of water.
Open the door carefully Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down around 15 minutes before removing from the
appliance. Open the dishwasher's door, leave it ajar and wait a few minutes before
removing the dishes. In this way they will be cooler and the drying will be improved.
Unloading the dishwasher It is normal that the dishwasher is wet inside.
WARNING: It is dangerous to open the door when washing, because the hot
water may scald you.
Page 21