Troubleshooting - Black & Decker BPD8W Manuel D'instructions

TROUBLESHOOTING & WARRANTY
Troubleshoot your problem by using the chart below. If the appliance still does not
work properly, contact the BLACK+DECKER customer service center. Customers
must never troubleshoot internal components.
TROUBLE
Dishwasher
doesn't start
Water not
pumped from
dishwasher
Suds in the tub
White film on
inside surface
There is
discolouration
or rust stains
on cutlery.
POSSIBLE CAUSE
Fuse blown, or the circuit
breaker tripped.
Power supply is not turned
on.
Door of dishwasher not
properly closed.
Kink in drain hose.
Filter clogged.
Kitchen sink clogged.
The type of detergent used
was not for dishwashers.
Spilled rinse-aid.
Hard water minerals.
The affected items are not
corrosion resistant.
POSSIBLE REMEDY
Replace fuse or reset circuit breaker.
Remove any other appliances sharing the
same circuit with the dishwasher.
Make sure the dishwasher is turned on and
the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Check to make sure there are no
obstructions. Close the dishwasher door
making sure it latches.
Check drain hose.
Check the coarse filter.
Check kitchen sink to make sure it is
draining well. If problem is kitchen sink or
plumbing, contact a plumber.
Make sure the detergent that was used
was dishwasher detergent. If a type of
soap or detergent was used that is not
for dishwasher use, open the door of the
dishwasher and let sudes evaporate. Add 1
gallon of cold water to the tub. Close and
latch the dishwasher, then Start the "soak"
wash cycle to drain out the water . Repeat
if necessary.
Always wipe up rinse-aid spills immediately.
To clean the interior, use a damp sponge. It
can be cleaned with a mild soap and water
solution. Make sure all soap residue is wiped
off after cleaning.
Only wash corrosion resistant/dishwasher
safe items in the dishwasher.
Page 27