Connect The Drain Hose - Black & Decker BPD8W Manuel D'instructions

SET UP & USE
To Disconnect the Quick Connect Assembly
1. Turn off hot water.
2. Relieve water pressure from the quick connect assembly before disconnecting it
from the faucet by depressing the red pressure relief button.
3. Depress the locking collar and remove the quick connect from the faucet.

CONNECT THE DRAIN HOSE

Insert the end of the drain hose into the drain outlet located at the back of the unit.
The other end of the hose should be positioned using one of the following methods:
A. Over the edge of a wash basin. Secure the
guide to the side of the basin wall with a hook
tap with a piece of string to prevent the drain
hose from moving.
B. In a laundry tub. The laundry tub should not be
higher than 39 in. (100cm). Wash basins should
not be over 39 in. (100cm).
C. In a standpipe. The standpipe should not be
longer than 39 in. (100cm).
D. Insert the drain hose into a drain pipe with a
minimum diameter of 1.5 inches (4 cm).
D
Rear of Dishwasher
NOTE: Avoid bending or crimping the drain hose. The free end of the hose must not
be immersed in water to avoid backflow. If you need a drain hose extension,
make sure to use a similar drain hose. It must not be longer than 13 feet (4
meters) otherwise the dishwasher will not drain properly.
Page 10
Drain hose
Water inlet
Drain outlet
A
Laundry tub
39 in. Max
32 in. Min
B
Hose
retainer
Tie
C
strap
tub
MIN diameter
1.5"(4cm)
Standpipe
Hose
retainer
Tie
strap
39 in. Max
MAX HEIGHT
39 in.
(100cm)