Echo CS-370 Manuel D'instructions page 8

1. Instruction manual - Included with unit. Read
before operation and keep for future reference to
learn proper, safe operating techniques.
2. Safety manual - Describe operating and safety
instructions for this chain saw.
3. Front hand guard - Guard between the front handle
and the saw chain for protecting the hand from
injuries and aiding in control of the chain saw if the
hand slips off the handle.This guard is used to lock
the chain brake which is to stop the saw chain
rotation.
4. Cleaner cover knob - Device for installing the air
cleaner cover.
5. Air cleaner cover - Covers air filter.
6. Purge pump - When starting engine, push purge
pump 3 or 4 times.
7. Choke control knob - Device for enriching the fuel/
air mixture in the carburetor to aid cold starting.
8. Rear hand guard - Extension on the lower part of
the rear handle for protecting the hand from the
chain if it breaks or degrooves.
9. Clutch cover - Protective cover to the guide bar,
saw chain, clutch and sprocket when the chain saw
is in use.
10. Chain tension adjuster - Device to adjust chain
tension.
11. Chain catcher - A projection designed to reduce the
risk of the operator's right hand from being hit by a
chain which has broken or derailed from the guide
bar during cutting.
12. Spiked bumper - Device, fitted in front of the guide
bar mounting point, acting as a pivot when in contact
with a tree or log.
CS-370
All manuals and user guides at all-guides.com
NOMENCLATURE OF PARTS
13. Guide bar - The part that supports and guides the
saw chain.
14. Saw chain - Chain, serving as a cutting tool.
15. Bar tip guard - Anti-kickback device attached on
the bar nose.
16. Cylinder cover - The cooling airflow grill. It covers
the cylinder, spark plug and silencer.
17. Front handle (for the left hand) - Support handle
located at the front of the engine housing.
18. Oil tank cap - For closing the oil tank.
19. Starter handle - Pull handle slowly until starter
engages then quickly and firmly. When engine
starts, return handle slowly. DO NOT let handle snap
back or damage to unit will occur.
20. Fuel tank cap - For closing the fuel tank.
21. Throttle latch - Device for temporality setting the
throttle in a partially open position to aid starting.
22. Throttle trigger - Device activated by the operator's
finger, for controlling the engine speed.
23. Rear handle (for the right hand) - Support handle
located towards the rear of the engine housing.
24. Throttle trigger lockout - A safety lever which must
be depressed before the throttle trigger can be
activated in order to prevent the accidental operation
of the throttle trigger.
25. Ignition switch - Device for connecting and discon-
necting the ignition system and thus allowing the
engine to be started or stopped.
8