Replacing Saw Chain; Replacement Parts - Remington 100582-01 Mode D'emploi

CLEANING AND MAINTENANCE
Continued

Replacing Saw Chain

Replace chain when cutters are too worn to sharpen or when
chain breaks. Only use replacement chain noted in this manual.
Always include new drive sprocket when replacing chain. This
will maintain proper driving of chain. Note: For proper chain
and drive sprocket, see Replacement Parts, below.
STORAGE
If storing saw for more than 30 days, follow steps below.
1. Drain oil tank.
2. Remove and clean guide bar and chain. Clean guide bar
and chain by soaking in petroleum based solvent or mild
soap and water mixture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil. This will prevent
rust.
5. Wipe a thin coating of oil over surface of guide bar.
6. Wipe off outside of saw body. Do this with soft cloth
dampened with a mild soap and water mixture.
7. Store chain saw
• in a high or locked place, out of children's reach
• in a dry place
• in a carrying case or with scabbard over guide bar
• with oil cap tight and saw upside down to prevent
excess oil seepage

REPLACEMENT PARTS

!
WARNING
WARNING ICON G 001
Use only replacement parts described in this
manual. Use of other parts could damage saw or
injure operator.
Purchase these parts from your local dealer.
Part Number
097572-03S
091375S
097570-01
091374S
075752
079417-03
All manuals and user guides at all-guides.com
Description
Guide bar, 400 mm (16")
Chain, 400 mm (16")
Guide bar, 355 mm (14")
Chain, 355 mm (14")
Drive sprocket
Wrench/Screwdriver
14 101241