Tools And Materials - CAME XVIA Manuel D'installation

Tools and materials

Make sure you have all the tools and materials you will need for installing in total safety and in compliance with applicable regulations. The figure shows some of
the equipment installers will need.
INSTALLATION
The following illustrations are mere examples. The space for fastening the turnstile and accessories varies depending on the overall dimensions. It is up to the
installer to find the most suitable solution.
⚠ Two people must assemble and fit the turnstile. To transport it and lift it, use proper hoisting equipment.
⚠ Risk of tipping over! Do not lean onto the turnstile until it is completely set.
Tracing for fitting the turnstile
The floor onto which the turnstile will be installed must be perfectly level.
If the turnstile is fitted up against a wall, leave at least 5 cm on the side opposite the tripod.
Once you have established the position, trace the axes as shown and mark them using a pencil.
Drill the marked holes and fit the anchors.
We suggest you use AISI 304 stainless steel nuts and bolts and in any case ones suitable to the type of floor you have; the holes on the structure have a Ø 11.
> 175
①
990
②
1070
③
900
④
1000
⑤
72
⑥
130
⑦
65
⑧
113
⑨