AEG EA 150 Notice D'utilisation page 15

EA150.book Seite 14 Freitag, 5. Dezember 2003 10:47 10
g
0 Insert your fingers into the holes in the
drip grating. Remove the drip grating
and rinse it under running water
(figure 12).
0 To empty it, hold the drip tray on both
sides and pull it forwards and out of
the appliance (figure 13).
0 Remove the plastic attachment with
the level indicator and rinse both
under running water (figure 14).
0 Place the plastic attachment with the
level indicator back into the drip tray.
0 Push the clean drip tray back into the
appliance and place the drip grating
back in.
Cleaning the brew filter
The brew filter through which the hot
water flows is located on the brew
head. Check from time to time to
ensure that the holes in the brew filter
have not become blocked by coffee
particles.
If the holes have become blocked:
0 Unscrew the brew filter using a coin
(figure 15).
0 Remove the brew filter and seal
(figure 16/1) and remove the brew
filter's seal (figure 16/2).
0 Clean the brew filter with warm water
and a brush.
0 Rinse the seal with warm rinse water.
3
If the appliance is to be transported at
temperatures below zero:
0 Empty the water tank.
0 Turn the selector dial (figure 1/G) to
the position and let the appliance
dry.
Decalcifying
If the espresso is flowing through the
filter at a slower rate than usual, it is
time for the appliance to be
decalcified.
We recommend that you decalcify the
machine once every three months with
liquid decalcifier. If you live in an area
with hard water the decalcifying
procedure may have to be carried out
14
All manuals and user guides at all-guides.com
0 Remove the power plug from the
0 Remove the steam nozzle with the
0 Place the filter holder in position
0 Place a sufficiently large container
0 Insert the power plug into the power
0 Afterwards, turn the selector dial
0 Then switch off the appliance and
0 Turn the selector dial (figure 1/G) to
0 Then thoroughly clean the water tank.
0 Fill the water tank with fresh water
0 After decalcifying the appliance,
more often. When doing this follow
the instructions provided by the
manufacturer of the decalcifier.
Important: Prior to decalcifying,
remove the brew filter (figure 1/U) and
the brew filter's seal, as described in
the section "Cleaning the brew filter"
(figures 15, 16).
First pour the water into the water
tank, then add the decalcifier; never in
the reverse order. At least 0.5 litres of
water must be used. The decalcifier
should be added accordingly.
power point and allow the appliance to
cool.
attachment (figure 1/H).
without the filter.
under the filter holder.
point and switch on the appliance.
(figure 1/G) to the position and let
approx. ¼ of the decalcifier flow
through the system.
allow the decalcifying solution to act
for approx. 10 minutes.
Repeat this procedure with an
additional ¼ of the decalcifying
solution.
the position. Allow the remaining
decalcifying solution to flow over the
nozzle and act for another 10 minutes.
and allow half to flow over the brew
head and the other half to flow over
the nozzle.
Repeat the procedure if there is a lot of
limescale.
replace the brew filter and seal.