Bestway HYDRIUM Serie Manuel De L'utilisateur page 8

IMPORTANT:
Before connecting the valve to the pool, first
fill the pool with water to a level that leaves roughly 2 in. - 2.5 in. (5-6 cm)
of space between the bottom of the valve and the top of the water
surface.
WARNING!
Never permanently install the connection valve
before the water is within a few centimeters of them because the liner
has to be properly taut from the pressure of the water.
NOTE:
a) Submerged suction fittings
b) Max flow rating for suction fittings: 44 GPM
c) Wall mounting only
d) Replace suction fitting within 1 installed year
e) Please note that the suction fitting including fasteners should be
observed for damage or tampering before each use of the pool
f ) Missing, broken, or cracked suction fittings shall be replaced before
using the pool
g) Loose suction fittings shall be reattached or replaced before using
the pool
15
#05
NOTE:
Be careful the splinters or any sharp edges when cutting
the pool.
IMPORTANT:
Cutting more liner than necessary will
damage and void the pool liner, so please trim with extra care.
A
C
A
B
A B
B
D
16
#08
17
#06
B
18
8
#04
2.5 in. (6 cm)
2 in. (5 cm)