Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
Istruzioni per l'uso
Mode d'emploi
Instrucciones de uso
Instruções de operação
Maintenance of the system
The system must be inspected visually, once a year, for any damage, leaks and contamination. Condensate can form in the sys-
tem after commissioning and during times of the year with strong outdoor temperature fl uctuations. This condensate disappears
however after a few hours exposure to sunlight.
Maintenance of anti-refl ective glass (AR glass)
To ensure and preserve the best possible performance of a collector with increased transmission glass (anti-refl ective glass or
AR glass for short), the following points in particular should be observed.
Use ...
•
Clean lifting gear, suction holders, and gloves
•
A cover for the glass vacuum lifter (material: Tyvek; replace when dirty)
•
Do not use the glass surface as a place to deposit installation material or other objects!
ATTENTION:
Clear the AR glass only with plain water or slightly soapy water!
The following can damage the anti-refl ective coating and thus prevent the system from achieving
its full performance!
AVOID ...
•
Getting fi ngerprints or stains on the glass
•
Using leather gloves
•
Contact with silicone, oil, grease, and any other thick, hydrophobic substances
•
Cleaning aids such as car polish, fl uoric acid, wire wool, wire brushes, polishing cloths,
•
Scouring powder, and fabrics containing metal yarn
•
Mechanical cleaning methods such as scrubbing, stripping, and high-pressure cleaning
10
30°
EN
20°
5-45°
Publicité
Table des Matières
