Changing The Water In The Boiler; Cup-Warmer (Where Contemplated) - La Cimbali M39 Dosatron TE Utilisation Et Installation

12. Changing the water in the boiler

Before operating the machine change the
water in the boiler."
Ensure that the indication on the display corresponds to
the working pressure value.
Keep a hot water distributor key (12) pressed down for
approximately 5 seconds.
The following message will be displayed: "WATER
CHANGE". The water from the boiler will drain from the
hot water nozzle (8) (60 - 70% ca. of the total capacity).
The boiler resistance and all dispensing keys will be disabled.
Dispensing will stop automatically (Note. The delivery can
be interrupted in whichever moment by means of the push
button STOP 35).
After the procedure, the machine will return to its normal
13. Cup Warmer (where applicable)
CAUTION: do not cover the cup warmer tray
with any type of cloth.
The machines have a cup tray (23) for stocking the cups.
Only place cups and glasses used with the coffee machine
on the cup tray. No other objects must be placed on
the tray.
Thoroughly drain the cups before placing them on the tray.
Note. The heating of the cup-warmer tray (23) is deactivated
during the automatic switch-off phase.
The condition in effect at the time when the machine was
switched off will be restored the next time the machine
automatically switches on.
By activating the ENERGY SAVING, mode the cup-warmer
is automatically set to Level 1.
To activate the resistance of the cup warmer tray (23) press
button (22
(22) key a number of times.
- All LEDS on = full power
- All LEDS off = OFF
To desactivated the heating of tray (23) press more times
the key (22) until all the leds are off.
12 35
8
NOTE: the "WATER CHANGE" function can be
programmed by the technical personnel: in this case, the
request message appears at the time set and the water
change cycle cannot be interrupted.
23
Furthermore, if the programming lock IS NOT set and the
customer programming is enabled, the singular heating
By holding down the cup warmer key
screen is activated:
CUP
< 050%
2) adjust the power percentage of the levels according to
their own needs with the keys
leaving the data unchanged by pressing the key
NOTE. With the programming lock active and customer
programming enabled, the user can only select the heating
level.
13 EN
12 12
22
WARMER
< 075% < 100%
.
or exit the menu
.