HQ Power VDP2301RGVLD10 Notice D'emploi page 8

VDP2301RGVLD10 - VDP2601RGYLD10 - VDP3801RGVLD10
• To start a new configuration, select New Config; to adjust and existing configuration, click Load Config.
Select the desired file in the pop-up window.
Global data:
• Set the DMX base address of the laser projector between 1 and 511.
When multiple laser projectors are linked, and they must produce the same output, their addresses must
be set to the same value and their CONFIG.DAT files must be identical.
If they are controlled individually, their addresses must be separated by 16 as each device needs 16 DMX
channels. So the first should be at 1, the second at 17 the third on 33 and so on.
DMX-Channels 1-16:
• Define the DMX channel numbers to control the laser animation. Every function must have a unique
channel number (1~16).
• Except for the first two parameter (show select L and show select H) all parameters can be set to a
fixed value by checking the none-box and entering the desired value in the dropdown box behind the
parameter or in the showtable below the parameters. In this case, the parameter can not be changed via
DMX anymore.
• The Show Select H parameter can be set to none by checking the checkbox. By doing this, only the first
16 files in the showtable are accessible.
show select L
show select H
Speed Kpps
Frame repeat
projection size
offset X
offset Y
Blank shift
Intensity
11/08/2011
Select one of the first 16 shows on the card (including pause). Each show occupies
16 DMX values.
Select one of the 16 banks of shows, each bank containing 16 shows (total=256
shows). A bank uses 16 DMX values.
Set the frame drawing speed (Kpps).
Note: this setting might influence the blank shift setting.
Control the animation speed.
Change the size of the projection (see important note below).
Changing the size too fast will result in a 'jumping' display.
0 = maximum negative offset
128 = centre position
255 = maximum positive offset
Note: projected display might 'jump' due to the slow DMX signal rate
0 = maximum negative offset
128 = centre position
255 = maximum positive offset
Note: projected display might 'jump' due to the slow DMX signal rate
Control the laser off-time between non-consecutive points of the frame.
Control the intensity of the laser output.
8 ©Velleman nv