Technical Data; Starting Operation; Working Instructions - Bosch GSC 160 Professional Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-552-001.book Page 6 Monday, October 22, 2007 4:15 PM
6 | English

Technical Data

Sheet Metal Shears
Article number
Rated power input
Output power
Stroke rate at no load n
0
Stroke speed under load
Steel sheet cutting
capacity, max.*
Smallest curve radius
Weight according to
EPTA-Procedure 01/2003
Protection class
2
* to 400 N/mm with reference to steel sheet
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your power tool. The trade names of individual tools may
vary.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the type plate of the
power tool.
Switching On and Off
To start the machine, push the On/Off switch 1
forwards.
To lock the On/Off switch 1, additionally push
down the front of the switch.
To switch off the machine, release the On/Off
switch 1. When the On/Off switch is locked, press
on the rear of the switch and then release it.
1 609 929 M54 | (22.10.07)

Working Instructions

Apply the power tool to the workpiece only when
GSC 160
switched on.
Professional
0 601 500 4..
W 500
W 270
spm 5000
spm 3500
mm 1.6
mm 35
Guide the power tool at an angle of 80 to 90° to
the surface of the sheet metal and do not tilt it to
kg 1.8
the side.
Guide the power tool evenly and with moderate
/ II
feed in the cutting direction. A high feed rate sig-
nificantly reduces the service life of the cutting
tools and can damage the machine.
Wear protective gloves while working and
pay particular attention to the mains cable.
Sharp burrs can develop at the cut steel sheet
and can cause injuries to the operator or dam-
age the mains cable.
Only work with the chip deflector 2 mount-
ed. Danger of injury when working without the
chip deflector.
When cutting curves, make sure not to tilt the
power tool laterally and work with low feed rate
only.
Maximum Steel Sheet Cutting Capacity
The maximum steel sheet cutting capacity d
depends on the strength properties of the mate-
rial to be cut.
The machine allows for cutting of metal sheet to
the following thicknesses:
Material
Steel
Aluminum
˚
80–90
Max. strength property
2
[N/mm ]
400
600
800
200
Bosch Power Tools
max
d
max
[mm]
1.6
1.2
0.7
2.2