Technical Data; Starting Operation; Working Instructions - Bosch GSC 2,8 Professional Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-610-001.book Page 6 Thursday, January 31, 2008 1:43 PM
6 | English

Technical Data

Sheet Metal Shears
Article number
Rated power input
Output power
Stroke rate at no load n
0
Stroke speed under load
Steel sheet cutting
capacity, max.*
Weight according to
EPTA-Procedure 01/2003
Protection class
2
* to 400 N/mm with reference to steel sheet
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your power tool. The trade names of individual tools may
vary.
Assembly
Before any work on the power tool itself,
pull the mains plug.
Auxiliary Handle (see figure A)
Unscrew the screw 3 out of the auxiliary handle
2 until the auxiliary handle fits into the auxiliary-
handle mount 4.
Slide the auxiliary handle 2 into the auxiliary-han-
dle mount 4. Tighten the auxiliary handle by turn-
ing in clockwise direction.
1 609 929 N57 | (31.1.08)
Operation
GSC 2,8

Starting Operation

Professional
Observe correct mains voltage! The voltage
0 601 506 1..
of the power source must agree with the
voltage specified on the type plate of the
W 500
power tool.
W 270
Switching On and Off
spm 2400
To start the machine, push the On/Off switch 1
spm 1500
forward so that the "I" is indicated on the switch.
To switch off the machine, push the On/Off
mm 2.8
switch 1 toward the rear so that the "0" is indi-
cated on the switch.
kg 2.7
/ II

Working Instructions

Apply the power tool to the workpiece only when
switched on.
Hold the power tool inclined at an angle of 15° to
the surface of the steel sheet and do not tilt it
laterally.
Guide the power tool evenly and with moderate
feed in the cutting direction. A high feed rate sig-
nificantly reduces the service life of the cutting
tools and can damage the machine.
Wear protective gloves while working and
pay particular attention to the mains cable.
Sharp burrs can develop at the cut steel sheet
and can cause injuries to the operator or dam-
age the mains cable.
When cutting curves, make sure not to tilt the
power tool laterally and work with low feed rate
only.
Bosch Power Tools