Panasonic CZ-RWSU2N Instructions D'installation page 16

Common to All Models
5-6. Setting Up Remote Controller Functions
The functions of the wireless remote controller can be set on site.
(These settings are saved in nonvolatile memory in the remote controller. Therefore, the settings
do not revert to the defaults even when its batteries are changed.)
<Note> Only service personnel should make the settings because the operation of the air
conditioner may be affected, depending on the settings made.
Furthermore, making changes to these settings may cause actual operation to deviate
from what is printed in the Operating Instructions, so be sure to fully explain this to the
customer.
Making Settings (Do with unit stopped)
(1) Holding down the swing/flap (
same time for 4 or more seconds will open the setting screen. (See figure below.)
(2) Use the Temperature setting buttons
(3) Use the ON timer buttons
(4) The settings are saved with the once/every day button (
displayed on the LCD changes from blinking to lighting.
(5) If other settings are to be changed, repeat steps (2) to (4).
(6) When all settings have been made, press the start/stop (
Operation procedure and function display
(3)
(4)
<Note 1> While the unit is in the SWING mode (swing/flap), the flap cannot be stopped in a
desired position.
<Note 2> When Setting OFF is selected, "°C" is displayed on the LCD.
<Note 3> You can toggle between ON and OFF by pressing ventilation "( ) button" for 4 seconds
or more.
<Note 4> If the Heater Max ON/OFF setting is not changed to EP (ON), the setting change will
not be reflected.
<Note 5> This is the number of addresses that can be set in the address change mode. Do not
set it to 07 or above.
16
) + OFF timer
/
/ ( ) to change settings.
Detected contents
Item
1 Operation Mode
Number
2 Flap Display
3 Select Fan Speed
(6)
4 Display of Set
Temperature
5 Time Display
(2)
6 Ventilation Fan
ON/OFF
7 Cool temp Max
8 Cool temp Min
9 Heat temp Max
10 Heat temp Min
11 Dry temp Max
12 Dry temp Min
(1)
13 Auto temp Max
14 Auto temp Min
16 Address Setting
Max Value
17 Heat temp Max
ON/OFF
( ) + mode select (
( ) to select the number of the item to be set.
). When this is done, the SET
) button.
Set Contents
(*1)
°C °F Setting Off (*2)
24 Hour (No Display)
OFF (No Display)
05 to 35°C
05 to 35°C
05 to 35°C
05 to 35°C
05 to 35°C
05 to 35°C
05 to 35°C
05 to 35°C
00 (ALL only)
JP (Heater Max Temp Change
Off) EP (ON)
) buttons at the
Factory
setting
(No Display)
(No Display)
°C
AM/PM 24 Hour
ON OFF
(*3)
30
18
30(*4)
16
30
18
27
17
01 to 031 06(*5)
JP