Duty Cycle - Porter Cable CPFAC2600P Manuel

All manuals and user guides at all-guides.com
SCFM or CFM: Standard Cubic Feet per Minute; a unit of measurement of air
delivery.
PSIG or PSI: Pounds per square inch gauge.
CUT-IN PRESSURE: While the motor is off, air tank pressure drops as you
continue to use your accessory or air tool. When the tank pressure drops to a
certain low level the motor will restart automatically. The low pressure at which
the motor automatically restarts is called "cut-in pressure."
CUT-OUT PRESSURE: When you turn on your air compressor and it begins to
run, air pressure in the air tank begins to build. It builds to a certain high pressure
before the motor automatically shuts off - protecting your air tank from pressure
higher than its capacity. The high pressure at which the motor shuts off is called
"cut-out pressure."
CODE CERTIFICATION: Products that bear one or more of the following marks:
UL, CUL, ETL, CETL, have been evaluated by OSHA certified indepenent safety
laboratories and meet the applicable Underwriters Laboratories Standards for
Safety.
Porter-Cable air compressors should be operated on not more than a 50% duty
cycle. This means an air compressor that pumps air more than 50% of one hour
is considered misused, because the air compressor is undersized for the required
air demand. Maximum compressor pumping time per hour is 30 minutes.
MODEL NO.
Horsepower-Peak
SCFM @ 40 psig
SCFM @ 90 psig
Cut-In
Cut-Out
Bore
Stroke
Voltage/Hertz/Phase
Minimum Branch Circuit
* Fuse Type
Amperage at Max. Load
Tank Size
* A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same
rating as the branch circuit on which the air compressor is operated. If
compressor is connected to a circuit protected by fuses, use only time delay
fuses. Time delay fuses should be marked "D" in Canada and "T" in the US.
D27856
GLOSSARY

DUTY CYCLE

SPECIFICATIONS
CPFAC2600P
2.0
3.7
2.6
120 PSI
150 PSI
1.875"
1.250"
120/60/1
15 Amp
Time Delay
10 Amps
6 Gallon
8 - ENG