Safety Instructions For All Operations - Stanley FatMax FME820 Manuel

f) Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and
control of the power tool in unexpected situations.
g) If devices are provided for the connection of dust extraction and collection facilities,
gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts.
ensure these are connected and properly used. Use of dust collection can reduce dust-
related hazards.
a) Do not force the power tool. Use the correct power tool for your application.
4) POWERTOOL USE AND CARE
b) Do not use the power tool if the switch does not turn it on and off. Any power
The correct power tool will do the job better and safer at the rate for which it was designed.
c) Disconnect the plug from the power source and/or the battery pack from the
tool that cannot be controlled with the switch is dangerous and must be repaired.
power tool before making any adjustments, changing accessories, or storing
power tools. Such preventive safety measures reduce the risk of starting the power
d) Store idle power tools out of the reach of children and do not allow persons
tool accidentally.
unfamiliar with the power tool or these instructions to operate the power tool.
e) Maintain power tools. Check for misalignment or binding of moving parts,
Power tools are dangerous in the hands of untrained users.
breakage of parts and any other condition that may affect the power tool's
operation. If damaged, have the power tool repaired before use. Many accidents
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
are caused by poorly maintained power tools.
g) Use the power tool, accessories and tool bits, etc. in accordance with these
cutting edges are less likely to bind and are easier to control.
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended could
result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.

SAFETY INSTRUCTIONS FOR ALL OPERATIONS

Safety Warnings Common for Grinding, Sanding, Wire Brushing or Abrasive
Cutting-Off Operations
a) This power tool is intended to function as a grinder, wire brush, sander or
specifications provided with this power tool. Failure to follow all instructions
cut-off tool. Read all safety warnings, instructions, illustrations and
listed below may result in electric shock, fire and/or serious injury.
this power tool. Operations for which the power tool was not designed may
b) Operations such as polishing are not recommended to be performed with
create a hazard and cause personal injury.
recommended by the tool manufacturer. Just because the accessory can be
c) Do not use accessories which are not specifically designed and
attached to your power tool, it does not assure safe operation.
speed marked on the power tool. Accessories running faster than their rated
d) The rated speed of the accessory must be at least equal to the maximum
speed can break and fly apart.
the capacity rating of your power tool. Incorrectly sized accessories cannot be
e) The outside diameter and the thickness of your accessory must be within
adequately guarded or controlled.
must properly fit the spindle of the power tool. Accessories with arbor holes
f) The arbor size of wheels, flanges, backing pads or any other accessory
that do not match the mounting hardware of the power tool will run out of balance,
vibrate excessively and may cause loss of control.
g) Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheel for chips and cracks, backing pad for cracks, tear
or excess wear, wire brush for loose or cracked wires. If power tool or
accessory is dropped, inspect for damage or install an undamaged
accessory. After inspecting and installing an accessory, position yourself
power tool at maximum no-load speed for one minute. Damaged accessories
and bystanders away from the plane of the rotating accessory and run the
will normally break apart during this test time.
3