Stiga XM140HD Mode D'emploi page 7

All manuals and user guides at all-guides.com
3.3 Clutch-parking brake (6:M)
(HD)
The pedal (6:M) has the follow-
ing three positions:
• Released. The clutch is not activated. The park-
ing brake is not activated.
• Depressed halfway. Forward drive disengaged.
The parking brake is not activated.
• Fully depressed. Forward drive disengaged.
The parking brake is fully activated but not
locked. This position is also used as emergency
brake.
3.4 Inhibitor, parking brake (6:N)
The inhibitor locks the (6:M) pedal in the
depressed position. This function is used
to lock the machine on slopes, during
transport, etc.
The parking brake must always be re-
leased during operation.
Locking:
1. Depress the pedal (6:M) fully.
2. Move the inhibitor (6:N) up.
3. Release the pedal (6:M).
4. Release the inhibitor (6:N).
Unlocking:
Press and release the "clutch-brake" (6:M) pedal.
3.5 Driving-service brake (6:O)
(HD)
If the machine does not brake as
expected when the pedal is released, the
left pedal (6:M) should be used as an
emergency brake.
The pedal (6:O) determines the gearing ratio be-
tween the engine and the drive wheels (= the
speed). When the pedal is released, the service
brake is activated.
1. Press the pedal forward –
the machine moves forward.
2. No load on the pedal – the ma-
chine is stationary.
3. Press the pedal backward –
the machine reverses.
4. Reduce the pressure on the
pedal – the machine brakes.
ENGLISH
3.6 THROTTLE/CHOKE CONTROL
(7:T)
A control for setting the engine speed and to choke
the engine when starting from cold.
If the engine runs unevenly there is a
risk that the control is too far forward
so that the choke is activated. This
damages the engine, increases fuel
consumption and is harmful to the
environment.
1. Choke – for starting a cold engine. The
choke is located in the top of the groove.
Avoid operating the machine in this
position, taking care to move the control
to full throttle (see below) when the
engine is warm.
2. Full throttle – when the machine is in
operation, full throttle should always be
used.
3. Idling.
3.7 IGNITION LOCK (7:U)
Ignition lock used for starting/stopping the engine.
Four positions:
1. Stop position – the engine is short-
circuited. The key can be removed.
2/3. Operating position.
4. Start position – the electric start motor
is activated when the key is turned to the
spring-loaded start position. Once the
engine has started, let the key return to
operating position 2/3.
3.8 GEAR LEVER (7:R) (Man)
A lever for selecting one of the five forward gears
in the gearbox (1-2-3-4-5), neutral (N) or reverse
(R).
The clutch pedal must be kept pressed in when
changing gear.
NOTE! You must make sure the machine is quite
stationary before changing from reverse to forward
gear or vice versa. If a gear does not engage
immediately, release the clutch pedal and then
press it in once again. Engage the gear once again.
Never force a gear in.
EN
7