NEC MultiSync FE950+ Manuel Utilisateur page 13

Caution: Please allow a minimum of 20 minutes to elapse between
uses of the Degauss function.
Size and Position Controls
Left/Right: Moves the image horizontally (left or right).
Down/Up: Moves the image vertically (up or down).
Narrow/Wide: Decreases or increases the horizontal size of the image.
Short/Tall: Decreases or increases the vertical size of the image.
Color Control/Color Control System
Color presets 1 through 5 selects the desired color setting. The bar is
replaced by the color setting choice from 1 to 5. Each color setting is
adjusted at the factory to the stated Kelvin. If a setting is adjusted, the
name of the setting will change from Kelvin to Custom.
Red, Green, Blue: AccuColor Control System decreases or increases
the monitor's red, green or blue color guns depending upon which is
selected. The change in color will appear on screen and the direction
(decrease or increase) will be shown by the bars.
sRGB Mode: sRGB mode provides the suitable color managed picture
image. You can not change Contrast, Brightness, Red, Green and Blue
colors individually.
Geometry Controls
Geometry Controls Menu
The Geometry controls allow you to adjust the curvature or angle of the
sides of your display.
Sides In/Out (pincushion): Decreases or increases the curvature of
the sides either inward or outward.
Sides Left/Right (pincushion balance): Decreases or increases the
curvature of the sides either to the left or right.
Sides Tilt (parallelogram): Decreases or increases the tilt of the sides
either to the left or right.
Sides Align (trapezoidal): Decreases or increases the bottom of the
screen to be the same as the top.
All manuals and user guides at all-guides.com
English-5