Table des Matières
Publicité
ENGLISH
END FOOT
The end foot allows the beam to rest when closing and thus
prevents the profile bending downward.
Attention: If a foot is installed, the balancing spring must be
readjusted.
FORK-SUPPORT FOR SPIN 6
SPIN 6
The fork has two functions:
• it prevents the beam, when closing, from bending and splitting
if its end is stressed by extraneous forces.
• it allows the beam to rest when closed and thus prevents the
profile bending downward.
POSITIONING THE FORK-SUPPORT FOUNDATION PLATE FOR SPIN 6
To position the fork-support foundation plate, refer to fig.23 where:
L = beam length (in mm)
A = L - 500 (in mm)
N.B.: For correct alignment, we advise you to position the fork-
410
Upright
support after fully installing the beam - in this way, the beam
will be correctly positioned at the centre of the fork.
All values in mm
N.B.: The values are purely indicative.
9. MAINTENANCE
To ensure correct long-term operation, carry out the following
checks every six months:
• check if all the safety devices in use are connected and
efficient.
• check if the anti-crushing clutch is correctly set.
• check the condition and efficiency of the earth connection.
• check if all screws are tight.
• check if the system is correctly balanced.
• check if the spring is in good condition
10. REPAIRS
For any repairs, strictly contact qualified personnel only.
Fig.22
A
Support
L
Fig.23
11. NOTES
Publicité
Table des Matières
