Main Components; Power Unit; Filter Package - Nederman 160E Serie Manuel D'instructions

EN 160E Series
dust from the filters. The dust falls down and is collected in the plastic sack of
the receptacle.
Very small particles can pass through the filter package and on to the micro-
filter (optional). This has a very high degree of separation, > 99.997% (DOP).
The cleaned air moves on to the high-pressure fan in the motor assembly.
The air leaves the appliance via noise-abating ducts in the motor assembly. If
flow-through is too small over a sufficiently long period, e.g. due to a closed
flap valve or blocked hose, the motors will become overheated. The suction
hose should therefore not be completely blocked for longer than a few seconds.
Clogged filters, which also reduce the flow of air, can result in overheating.
The appliance should not be used as a stationary vacuum appliance because of
the danger of overheating.
5

Main components

5.1

Power unit

See Figure 1. The motor assembly includes fan motor, connection cable and
starting equipment. Some models are equipped with automatic electric starters.
5.1.1 Maintenance
Replace the fan motors in the motor assembly if they are not working
satisfactorily. The motors' carbon brushes are worn out after about 700 hours
of operation. Replacing the motor's carbon brushes more than once is not
recommended. The motor collector becomes worn and new brushes will wear
very quickly. Replace the entire motor instead. The motor is accessible after
unscrewing the motor assembly.
5.2 Filter/Filter package
CAUTION!
The appliance should never be operated with a filter bag only, but should
always be equipped with another filter. Check regularly that the filter is not
defective.
5.3 Micro-filter (optional)
5.3.1 Installation/replacement
See Figures 2–3. Change the micro-filter once a year or more often if
vacuum performance decreases despite cleaning the fine filters. Installation/
replacement of micro-filter, see Figure 3. Use genuine micro-filters only.
Ensure that the rubber gasket on the filter seals tightly against the bottom of
the motor assembly. Leakage between micro-filter and fan inlet must not occur.
Use an approved breathing mask when changing the filters.
5.3.2

Filter package

See Figure 4.
Filter package, Cartridge (4a)
The particles collect on the outside of the filter. Cleaning of the filter is
carried out hourly or when the vacuum performance decreases. If required the
cartridge filter should be changed.
12
All manuals and user guides at all-guides.com