Eskimo QuickFlip 1 Manuel De L'utilisateur page 8

skirt
edge trim
sled
13
Pull the skin taut and push the edge trim over lip
of the sled with the shelter skin between the two.
It is important to keep the skin taut and work the
edge trim evenly around both sides of the shelter
until all edge trim is in place. SEE FIGURE 8.
NOTE: When pulling the shelter skin tight, DO NOT lift the
lower frame support off the ground. Make sure all spreader
poles are properly installed before the edge trim is at-
tached to ensure a proper fit. Using a rubber mallet may
be helpful while attaching the edge trim to the sled lip.
ADDITIONAL INSTALLATION
15
Locate the included 8 foot tow rope that was in
the hardware bag. To install the tow rope locate
the two holes in the front of the sled and push
each end of the rope through a hole. Tie a knot at
each end of the rope to keep the rope from pull-
ing through the holes. This tow rope is designed
for manual pulling by hand only. DO NOT tow
behind a motorized vehicle with rope. For high-
speed towing, you should purchase the Eskimo
Universal Tow Hitch accessory (#11608).
8
All manuals and user guides at all-guides.com
14
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
#6 - 3/8" screw
edge trim
Secure the edge trim in place using the (12) #6 x
3/8" sheet metal screws provided. A cordless drill
and Phillips head bit is recommended for this
step, but is not necessary. SEE FIGURE 9.
NOTE: Screws should be spaced evenly apart. This step
does mean you will put very small holes in your shelter skin
to keep the edge trim and skin securely attached to the
sled lip. This will in no way affect the performance of your
shelter.
Operator's Manual
ESKIMO QuickFlip 1
®
™
skin
sled