Bolt Identification Chart; Assembly - Eskimo QuickFlip 1 Manuel De L'utilisateur

BOLT IDENTIFICATION CHART

• Not all bolt sizes shown are included with all
shelters. Bolts shown are for size reference only.
Extra hardware may be included in the parts bag.
BOLT 1/4-20 X 3/4" HH GR5 ZN
BOLT 1/4-20 X 2-1/2" PTH GR5 ZN
#27825
1
Attach the Hinge (#27825) to the upper lip of
the tub using (2) ¼-20 X 3/4" bolts, (2) ¼" wash-
ers, and (2) ¼-20 nylock nuts. Repeat this step
on the opposite side. SEE FIGURE 1.
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
All manuals and user guides at all-guides.com
SEE
DETAIL
ASSEMBLY INSTRUCTIONS
TOOLS NEEDED:
• (2) 7/16" wrenches and/or socket driver
• Phillips head screwdriver
• Rubber mallet (optional)
• Cordless drill (optional)
IMPORTANT ASSEMBLY TIP
DO NOT FULLY TIGHTEN ANY NUT AND BOLT COMBINATION UNTIL
INSTRUCTED IN LATER NOTES. THIS WILL HELP WITH HOLE ALIGN-
MENT FOR ALL PARTS.
ASSEMBLY TIPS:
• This ice shelter should be assembled in an indoor setting due to the
time and length of assembly. Identify and familiarize yourself with all
parts and hardware before assembly. Allow 1-2 hours for assembly.
• The use of a cordless drill with socket will make assembly of your
ice shelter much quicker. Be sure to set the drill speed on low so
you do not over tighten any nut and bolt combination.
• If a tracking kit is purchased with the shelter it should be mounted
to the sled before assembly of the ice shelter for convenience.
#27825
#11203
2
Attach the (1) hinge support brace (#11203) to
the hinge (#27825) using (2) ¼-20 X 3/4" bolts,
(3) ¼" washers, and (2) ¼-20 nylock nuts. Repeat
this step on the opposite side. SEE FIGURE 2.
NOTE: If the hole alignment is off or looks too far apart,
rotate the hinge support brace and try again. This part
will only bolt on one way.
NOTE: Tighten all hardware used to complete this
portion of assembly instructions.
Operator's Manual
ESKIMO
QuickFlip
® ™
SEE
DETAIL
1
5