Eskimo QuickFlip 1 Manuel De L'utilisateur page 7

Masquer les pouces Voir aussi pour QuickFlip 1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Pole Sleeve
8
Unfold the skin and locate the Eskimo® logo
near the zippered door, which is in the front of
the sled. With the outer part of the shelter skin
lying face down, locate the (3) pole sleeves on
the bottom front, right side, and left side of the
shelter skin. Slide the remaining frame support
pole (#27500) through the (3) pole sleeves.
SEE FIGURE 6.
10
It is now time to drape the shelter skin over
the top of the frame. Start by lifting the rear
of the shelter skin over the top of the front
frame support. Make sure that you are evenly
working the shelter skin over the supports.
Continue working the shelter skin over the
rest of the frame supports until the shelter
skin lies evenly over the entire shelter.
NOTE: Attaching the skin can be a difficult task and is
easiest with two people to ensure proper installation
and desired fit.
11
Once the shelter skin is on the frame, move to
the inside of the shelter and attach the hook
and loop retainers to the frame supports.
There will be four hook and loop retainers per
frame support.
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
All manuals and user guides at all-guides.com
Skin
9
12
*Skin not pictured
#27500
Assemble the frame U section (#27500) to the
end of the (2) frame uprights (#27501) using
(4) #8 x ½" sheet metal screws at the predrilled
holes in #27500. SEE FIGURE 7.
After attaching all of the hook and loop retain-
ers you are ready to install the edge trim to the
rear of the shelter. Move to the outside of the
shelter and start by identifying the edge trim
piece (#69654) from the parts box. Locate the
center of the edge trim piece by folding it in
half. Line up the center of the edge trim to the
best of your ability with the center of the rear
of the shelter.
Operator's Manual
ESKIMO
QuickFlip
1
®
#27501
7

Publicité

Chapitres

Table des Matières
loading

Table des Matières