Before First Use; Mounting The Side Brushes - Philips FC8820 Mode D'emploi

How your robot avoids height differences
The robot has three drop-off sensors in its bottom. It uses these
-
drop-off sensors to detect and avoid height differences such as staircases.
Note: It is normal for the robot to move slightly over the edge of a height
difference, as its front drop-off sensor is located behind the bumper.
Caution: In some cases, the drop-off sensors may not detect a staircase
or other height difference in time. Therefore monitor the robot carefully
the first few times you use it, and when you operate it near a staircase
or another height difference.

Before first use

Mounting the side brushes

Unpack the side brushes and place the robot upside down on a table
1
or on the floor.
2 Push the side brushes onto the shafts on the bottom of the robot.
Note: Make sure you attach the side brushes properly. Press them onto the
shaft until you hear them lock into position with a click.
Inserting the rechargeable battery into the robot
You have to insert the rechargeable battery before use.
1 Press the ribbed sections on the battery cavity cover to unlock it.
2 Slide the battery cavity cover off the robot.
3 Remove the plastic from the rechargeable battery.
ENGLISH
9