Philips FC8820 Mode D'emploi page 13

2 Unless you press one of the mode buttons, the robot continues
cleaning in auto cleaning mode until its battery runs low. In auto
cleaning mode it follows repeated sequences of Z-pattern,
random, wall-following and spiral movements. For more information
on the cleaning modes, see section 'Cleaning modes'.
When the battery runs low, the light in the on/off button starts
3
flashing and the robot returns to the docking station to charge.
4 You can also press the on/off button to interrupt or stop the
cleaning run. If you press the on/off button again and there is still
enough energy in the rechargeable battery, the robot continues
cleaning in the auto cleaning mode.
5 You can also make the robot return to the docking station before
the rechargeable battery runs low by pressing the docking button on
the remote control or the pointer (FC8820). The docking indicator
on the display of the robot lights up and the robot returns to the
docking station.
Note: If you did not start the robot from the docking station, it does not return
to the docking station automatically when the rechargeable battery runs
low. If there is still enough energy in the rechargeable battery, you can press
the docking button to make the robot return to the docking station. If the
rechargeable battery is completely empty, you have to place the robot on the
docking station manually.
Cleaning modes
Next to the auto cleaning mode, this robot has four individual cleaning
modes that can each be activated by pressing the appropriate button.
Z-pattern mode
In Z-pattern mode, the robot cleans by making Z-shaped loops
-
through the room to clean large areas.
ENGLISH
13