Philips FC8820 Mode D'emploi page 18

ENGLISH
18
Using the pointer (FC8820)
Charging the pointer
The pointer has a rechargeable battery that can be charged with the
USB cable supplied.
1 Insert the micro-USB plug into the socket in the bottom of the
pointer.
2 Insert the USB plug into a USB charger or a USB port on your
laptop.
3 The charging light on the pointer lights up solid. Charging takes
30 minutes. When the charging light goes off, the rechargeable
battery is fully charged.
Navigating the robot with the pointer
- When you press and hold the pointer button, the pointer emits a beam
of infrared light. With this beam you can drag the robot in a particular
direction. As long as you keep the button pressed and keep pointing
in the direction you want the robot to move, it continues to move in
that direction. When you release the pointer button, the robot starts
cleaning in auto cleaning mode.
With the pointer you can send the robot to a specific area in the room
-
to give this area an extra-thorough clean.
Using the virtual wall unit (FC8820)
Placing the batteries in the virtual wall unit
The virtual wall unit operates on four AA batteries.
Push the two release tabs at the bottom of the back cover (1)
1
and slide the back cover upwards and off the virtual wall unit (2).