Charging The Shaver; Indicator Lights - Braun FreeGlider 6680 Mode D'emploi

Charging the shaver

• First charging: Using the low-voltage adapter, connect
the shaver to an electrical outlet. Allow it to charge for at
least 4 hours. During charging shaver and adapter might
get warm. Once the shaver is completely charged,
disconnect it. Shave until fully discharged. Then recon-
nect and recharge to full capacity again (subsequent
charges will take about 1 hour).
• When the shaver is completely discharged, you cannot
know if it is switched on or not. When you connect
the shaver to an electrical outlet, make sure the green
charging light illuminates. If it does not, push the start/
stop button (turning off the shaver). The shaver is only
charging when the green light is on.
• A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth. However,
the maximum battery capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for charging is
60 °F to 95 °F / 15 °C to 35 °C.

Indicator lights

The green charging light shows that the shaver is being
charged. When the rechargeable battery is fully charged,
the charging light goes off. If later on, the charging light
comes on again, this indicates that the shaver is being
recharged to maintain its full capacity.
The red low charge light glows when the battery capacity
has dropped below 20%, provided the shaver is
switched on. The remaining capacity will then be
sufficient for 2 to 3 shaves.
Preserving the cell unit
In order to maintain the optimum capacity of the
rechargeable battery, the shaver has to be fully dis-
charged (by shaving) every 6 months approximately.
Then recharge the shaver to full capacity again.
stop stop
7