CARLO GAVAZZI WM50 Serie Manuel D'instructions page 36

From WM50
To reset...
all variable values
values concern only the variables in a measurement
page
From UCS
1. Connect WM50 to UCS.
2. In settings, open the reset section.
Communicating with other devices
Communicated via M C ETH module
1. Make sure the module is correctly installed.
2. Set network parameters via WM50 keypad or from USC mobile connected with OptoProg.
3. Connect WM50 to the master via Ethernet cable to the LAN or directly (point to point connection).
4. Create communications via mater (PC, VMU-C, PLC, etc.) connected to the same LAN or connected point to point.
Note: the module starts to communicate about 15-30 s after WM50 is turned on.
Communicated via M C 485 232 module
1. Make sure the module is correctly installed.
2. If necessary, set serial communication parameters via WM50 keypad or from USC mobile connected with OptoProg.
3. Connect WM50 to the master.
4. Create communications via master (PC; VMU-C, PLC, etc.).
Communicated via OptoProg
See relevant instruction manual.
Then...
in the settings menu, in sub-menu Reset select the page for the values to
be reset
in the variable measurement page to reset values:
press and hold down (1.5 s) the key
l
scroll the pages until the values to be reset are displayed and confirm.
l
WM50 - Instruction manual | 26/04/2022 | CARLO GAVAZZI Controls SpA
Other operations
or .
ys
/
35