Hood Cleaning - Best K260A Guide D'installation

Masquer les pouces Voir aussi pour K260A:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

14. INSTALL BAFFLE FILTERS
Remove protective plastic film covering filters before installing them.
NOTES: 1. Assemble the metal handles to the filters, using no. 8-32 x 1/4" screws provided, before
installing them in the hood.
2. A vertical arrow with the word AIR can be found on the filter border. Ensure to install the
filters with this arrow pointing toward the inside of the hood (as illustrated below).
It is recommended to install side filters first and finish with center
one(s).
1. Insert front end of the filter inside front of the hood.
2. Raise lower end toward the inside of hood and insert into
channel.
3. Slide filter under the inner retaining piece.
HD0095
15. USE AND CARE
Baffle filters and impeller(s)
The baffle filters and impeller(s) should be cleaned frequently. Use a warm detergent solution. Baffle
filters and impeller(s) are dishwasher safe.
Remove filters by pushing them towards the back of hood and rotating them downward.
Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of the filter may
occur if using phosphate detergent or as a result of local water conditions—but this will not affect filter
performance. This discoloration is not covered by the warranty.

Hood cleaning

Stainless steel cleaning:
Do:
• Regularly wash with clean cloth or rag soaked
with warm water and mild soap or liquid dish
detergent.
• Always clean in the direction of original polish
lines.
• Always rinse well with clear water (2 or 3
times) after cleaning. Wipe dry completely.
• You may also use a specialized household
stainless steel cleaner.
Avoid when choosing a detergent:
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are
highly explosive and should never be used close to a range.
CAUTION
Don't:
• Use any steel or stainless steel wool or any
other scrapers to remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction
residues reach the hood. During construction/
renovation, cover the hood to make sure no
dust sticks to stainless steel surface.
10
1
3
2
HD0104

Publicité

Table des Matières
loading

Table des Matières