Human Touch JADE HEAT Mode D'emploi Et D'entretien page 5

INSTALL THE POWER HUB
1. Gently turn the chair onto its left-hand side (Fig.6).
2. Locate the four screw holes on the bottom of the front cross bar (Fig.7).
3. Using a Phillips-head screwdriver, secure the power hub to the chair with the cord facing upward,
using the four provided screws (Fig.8).
4. Leaving approximately two feet of the chair power cord, coil the excess cord neatly (Fig.9).
5. Open the pocket on the bottom of the chair canvas, then tuck the coiled cord into the lower pocket (Fig.9).
Front cross bar
Fig.6
Power hub
power cord
Fig.8
humantouch.com
Front cross bar
Fig.7
Coiled
Fig.9
6
6. Plug the chair power cord into the power hub (Fig.10).
7. Plug the transformer into the power hub outlet (Fig.10).
8. Feed the transformer plug up through the hole in the chair canvas (Fig.11).
9. Gently return the chair to the upright position.
Chair power cord
Fig.10
Transformer plug
Fig.11
Transformer
Transformer plug
7