Classic Accessories The Roanoke Manuel De L'utilisateur page 11

R O A N O K E P O N T O O N B O A T O W N E R ' S M A N U A L
Now attach the two inside and two outside webbing straps
on the pontoon to the pontoon frame. Thread the straps as follows:
1. Through the frame...
5.
2. Back to the buckle...
2.
3. Through the buckle threading path...
4. Match the rip-and-grip to each other.
5. Fold the remaining webbing - trapping it between the pontoon and
4. 1.
webbing. Repeat for the remaining three straps.
5. Inflate the pontoon completely.
Inflate to approximately 2.5 psi (0.17 BAR).
3.
Inflate until firm but not hard. DO NOT over inflate.
Repeat the procedure with the left pontoon.
6. Attach the seat to the seat frame.
Locate the four 2 inch (5 cm) screws coming out
of the bottom of the seat. Unscrew the wing
nuts and remove the washers and lock washers.
Place the seat with screws facing downwards
into the four holes on the seat frame. Attach the
washers, lock washers and wing nuts onto the
screws and tighten to hold the seat in place.
7. Attach the seat frame to the pontoon frames.
Insert the seat platform tubes onto the pontoon frame posts with the seat facing the front. The front
of the pontoon frames are the ends labeled "L" (left) and "R" (right). (You may need to LIGHTLY tap
the frames with a rubber mallet to fit).
Align the holes and secure with four clevis
pins.
You MUST lock the security retainers on all
four clevis pins to insure that the frame stays
together.
Insert clevis pins on the frame side not in
between bladder and frame to avoid abrasion
of pontoon.
11