Assembly And Use - Classic Accessories The Roanoke Manuel De L'utilisateur

R O A N O K E P O N T O O N B O A T O W N E R ' S M A N U A L
A S S E M B L Y A N D U S E
1. Confirm that all the parts are present.
(See the parts list on page 9).
2. Identify the right and left pontoons.
You can identify the right and left pontoons by the "R" (right) and "L" (left) labels
sewn on the inside of the pocket on top of each.
3. Partially inflate the air bladders.
The valve is located on the top of the pontoons in front of the main
pocket.
The valve has a center button that opens and closes the valve by
simply pushing down, and turning a quarter turn. THE VALVE IS OPEN
WHEN THE CENTER BUTTON IS DOWN,
AND CLOSED WHEN IT IS UP. BEFORE
INFLATING, MAKE SURE THE VALVE IS
IN THE CLOSED POSITION.
Unscrew the valve cap, make sure the
valve is closed and insert the inflation
adapter into the valve and twist to
secure. Inflate using a foot pump or air
compressor with a cone-type nozzle
fitting.
Inflate the pontoon to about 3/4
full. Do not inflate beyond 3/4 full
because it will make the next step
very difficult—attaching the pontoons
to the frame.
Repeat this step with the other pontoon. You will fully inflate the
pontoons in step 5
4. Attach the pontoons to the frames.
Each pontoon attaches to a metal pontoon frame
with four webbing attachment straps.
Locate the left and right pontoon frames.
On the front of each pontoon frame (where the front
of the
boat will be) there is a "L" (left) or "R" (right) label
indicating left or right.
Place a right pontoon frame on top of the
right pontoon as shown. There is a "L" (left) or "R"
(right) label inside the pocket of each pontoon).
The longest straight tube of each frame should be
on the same side of the pontoon as the pontoon
zipper.
A
B
Inflation Valve
Press and
turn on
center
button
D
Strap
Attachment
Buckle
Web Path
Long Strap
Long Strap
10
C
Insert
into
valve and
twist to
inflate
Pontoon Frame
Short Strap
FRONT
Inflation
adapter
Right hand
pontoon and
frame
Short Strap
Zipper