Technical Specification - Nicols PAR LED 188 FC Notice D'utilisation

TECHNICAL SPECIFICATION


Power supply : AC 100V-240V, 60Hz/50Hz

LED : 18 X 8W RGBW

Consumption : 120W

LED display

Working modes : Built-in Programs, Auto Running Mode, DMX mode, Sound-Active, Master/Slave and Static Color

DMX channels : 4, 5, 8

Beam angle: 40°
OPERATION
BUILT-IN PROGRAMS
1.
a. Press MODE until Pr.01 shows. Press SETUP.
b. Use buttons UP and DOWN to switch from one program to another: Pr.01 to Pr.11. Press SETUP.
c. In Pr.01, you have access to Static Color. Press UP and DOWN buttons to select a color. Then adjust strobe
speed :
d. In Pr.02 to Pr.07 :
adjust running speed :
-
Adjust strobe speed :
-
STATIC COLOR (Pr.01)
-r RED
-rg RED AND GREEN
-g GREEN
-gb GREEN AND BLUE
-b BLUE
-rb RED AND BLUE
rgb RED, GREEN AND BLUE
-w WHITE
-FL
RED, GREEN, BLUE AND WHITE
-rw RED AND WHITE
-gw GREEN AND WHITE
-bw BLUE AND WHITE
-yw YELLOW AND WHITE
-uw
WARM WHITE
AUTO running mode :
2.
Press MODE, when AUTO is on, press SETUP. You'll be able to adjust running speed, strobe speed and effects.
MASTER/SLAVE mode
3.
To set the device under SLAVE mode, press on MODE until SLAv is on.
SOUND-ACTIVE mode
4.
a. Press on MODE until « SU.xx » is on, then press SETUP
b. Adjust sound sensitivity from SU00 to SU31 with UP and DOWN buttons
DMX mode
5.
a. Press MODE, when "d.xxx" is on, press SETUP.
b. 1 subfolder: set a DMX address with UP and DOWN buttons from d.001 to d.512.
st
c. 2 subfolder: set a DMX channel with UP and DOWN buttons: 4-ch, 5-ch or 8-ch
nd
Under mode 8-ch, you can set up an ID value for each device: ID .01 to ID.66
All manuals and user guides at all-guides.com