Safety Instruction; Technical Specification - Nicols IP WASH 240 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Safety Instruction

Please read carefully the instruction which includes important information
about the installation, usage and maintenance.
WARNING
 Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction
booklet.
 Unpack and check carefully there is no transportation damage before using the unit.
 Before operating, ensure that the voltage and frequency of power supply match the power requirements of the unit.
 It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
 Suitable for both indoor & outdoor use.
 The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces.
 Disconnect mains power before replacement or servicing.
 Make sure there is no flammable materials close to the unit while operating as it is fire hazard.
 Use safety cable when fixes this unit under ceiling or on the truss.
 Maximum ambient temperature is ta: 40℃. Don't operate it where the temperature is higher than this.
 Unit surface temperature may reach up to 60℃. Don't touch the housing bare-hand during its operation. Turn off the power and allow
about 15 minutes for the unit to cool down before replacing or serving.
 In the event of serious operating problem, stop using the unit immediately. Never try to repair the unit by yourself. Repairs carried out by
unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance center. Always use the
same type spare parts.
Do not touch any wire during operation as high voltage might be causing electric shock.
 Do not open the unit within five minutes after switching off.
 Make sure that the housing is firmly closed and all screws are tightly fastened when operate.
Caution
There are no user serviceable parts inside the unit. Do not open the housing or attempt any repair yourself. In the unlikely event your
unit may require service, please contact your nearest dealer.
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid vibration and slipping
while operating. Always ensure that the structure to which you are attaching the unit is secure and is able to support a weight of 20
times of the unit.

2. Technical Specification

IP WASH 240
LED PANEL 24X10W RGBW FC IP with barn doors
This product is designed for outdoor use. Suitable applications include wash or effect lighting for architectural, stage or nightclub
applications.
This product can also be installed for use in signage and advertising using the dynamic functions available with DMX512 controller. This
product can be operated as a single unit or in multiple units for large applications.
* Light source: 24X10W (RGBW 4 in 1 LED)
* DMX channel: 9
* Control: Auto, DMX, Master/Slave
* IP rating: 66
* 16 chases
* Beam angle: 35°
* Lifespan: 50 000 H
* Lumens: 6600 lux @ 2M
* Voltage: AC100-240V, 50/60Hz
* Size: 670 x 105 x 230 mm
* Net weight: 7,9kg

Publicité

Table des Matières
loading

Table des Matières