Clock And Timers; Setting The Clock; Sleep Timer; Play Timer - Panasonic SC-PM500 Manuel D'utilisation

Manual presetting
1
Press [3] or [5] to tune in to the station.
2
Press [PROGRAM].
3
Press the numeric buttons to select a preset
number.
Do steps 1 through 3 again to preset more stations.
The new station replaces any station that occupies the
same preset number.
Selecting a preset station
Press the numeric buttons, [2] or [6] (main unit:
[2/3] or [5/6]) to select the preset station.
FM or AM allocation setting
This system can also receive FM broadcasts allocated in
0.1 MHz steps or AM broadcasts allocated in 9 kHz steps.
1
Press [RADIO/EXT-IN(USB)] to select "FM" or
"AM".
2
Press and hold [RADIO/EXT-IN(USB)].
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps
again.
• After you change the setting, preset frequencies are
erased.
PM500_PC1_1us.indd 11 PM500_PC1_1us.indd 11
All manuals and user guides at all-guides.com

Clock and timers

Setting the clock

This is a 12-hour clock.
1
Press [CLOCK/TIMER] to select "CLOCK".
2
Within 10 seconds, press [R, T] to set the time.
3
Press [OK].
Press [CLOCK/TIMER] to show the clock for a few
seconds.
Note:
Reset the clock regularly to maintain accuracy.

Sleep timer

(by main unit only)
The sleep timer switches off the system after the set time.
Press [SLEEP] to select the setting (in minutes).
To cancel, select "OFF".
30 MIN → 60 MIN → 90 MIN → 120 MIN → OFF
To show the remaining time
Press [SLEEP].
Note:
• The sleep timer can be used together with the play timer.
• The sleep timer always comes first. Be sure not to set an
overlap of timers.

Play timer

You can set the timer to come on at a certain time to wake
you up.
Switch on the system and set the clock.
Prepare the music source you want to listen to (disc, radio,
USB, iPod or iPhone) and set the volume.
1
Press [CLOCK/TIMER] to select "#PLAY 1",
"#PLAY 2" or "#PLAY 3".
2
Within 10 seconds, press [R, T] to set the start
time.
3
Press [OK].
4
Do steps 2 and 3 again to set the end time.
To start the timer
5
Press [#, PLAY] to start "#PLAY 1", "#PLAY 2" or
"#PLAY 3".
6
Press [`] to switch off the system.
The system must be switched off for the timer to
operate.
Change the Do steps 1 through 4 and 6 again
settings (Z above).
Change the
1) Press [#, PLAY] two times to remove
source or
the timer indicator on the display
volume
panel.
2) Change the source or volume.
3) Do steps 5 and 6 (Z above).
Check the Press [CLOCK/TIMER] to select
settings "#PLAY 1", "#PLAY 2" or "#PLAY 3".
Cancel
Press [#, PLAY] two times to remove the
timer indicator on the display panel.
Note:
• The timer starts at a low volume and increases gradually
to the preset level.
• The timer comes on at the set time every day if the timer
is on.
• If you switch off the system and switch on again while
a timer is in operation, the timer will not stop at the end
time.
11
11
7/14/2011 12:13:03 PM 7/14/2011 12:13:03 PM