A.T.I.B. HFK - HFT Série Manuel D'utilisation Et Entretien page 13

Stop
Stop
F 00
Stage 0.0
F 10
Stage 1.0
F 20
Stage 2.0
F 30
Stage 3.0
end4
Stage 4
End5
Stage 5
end
End
endb
End
wait
Wait
bat
Battery
bat1
Battery 1
bat9
Battery 9
t' I
t° IGBT
t'D1
t° Diode
t'd2
t° Diode
cur
Current
main
Main
time
Time F1
tout
Tmax
ON-OFF button
Pressing P4 button during the charge the display shows off
Pressing P4 again the Charger switches off. The display shows Stop
After switching off, wait until the display shows bat before starting a new
charge.
ATIB ELETTRONICA S.R.L V
Addendum Release
Main Parameter
Charger is idle. Battery can be disconnected avoiding electric arcs
Starting charge.
Bulk stage (before gassing point).
Absorption stage - Constant voltage (gassing point threshold)
Final stage - Low constant current.
Floating stage. Main charge is completed
Stage 4 – fixed floating ; Stage 5 – pulse floating;
Charge is over. Cycle completed. Battery can be disconnected.
Charge is over. Cycle short. Battery was likely full charged or sulphated.
Charge is not started yet. A delayed start has been set.
Battery not connected. It simply means it should be connected. If not
means battery voltage too low or output fuse blown.
Battery undervoltage. Battery is under of the setting range.
Battery overvoltage.
IGBT overheating. Charger is waiting for cooling or probe failure
Diode 1 overheating. Charger is waiting for cooling or probe failure
Diode 2 overheating. Charger is waiting for cooling or probe failure
Current below minimal threshold.
One or more of AC main phases is missing or one or more input fuses
into wall socket or into the charger are blown.
Stage 1 maximum time. Gassing point is not reached within this time.
Global charging time. Charging cycle has exceeded this safety time.
I , 29 Z.I. B
IA NDUSTRIALE ARBARIGA
5.10 F
Error Codes
(BS) Tel. +39 030 99 71 051 E-mail: tecnico@atibelettronica.it
1 / 1
26 mar 2014 (dd/mm/yy)
E 0
E 0
E 0
E 0
E 0
E 0
E 0
E 0
E 19
E 1
E 3
E 12
E 4
E 5
E 6
E 10
E 11
E 7
E 7