Installing Guide Bar And Saw Chain - Makita EA3600F Manuel D'instructions

ASSEMBLY
WARNING:
• Before performing any work on the guide bar or saw chain, always switch off the
engine and make sure that the cutting tool is stopped.
• Always wear protective gloves.
CAUTION:
• Start the chain saw only after having assembled it completely and inspected.

Installing guide bar and saw chain

NOTICE:
• Installing or removing saw chain should be carried out in a clean place free from
sawdust or other foreign material.
Put the chain saw on a stable surface and carry out the following steps:
1. Release the chain brake by pulling the front hand guard.
2. Loosen chain tension fully.
3. (For model EA3600F) Unscrew the retaining nuts.
(For model EA3601F, EA3601FG) Press and fully open the lever until it stops.
Turn the lever counterclockwise.
4. Remove the chain cover.
NOTICE:
• You can not remove the chain cover without releasing the chain brake.
All manuals and user guides at all-guides.com
13
EA3600F
EA3601F
EA3601FG
EA3601F
EA3601FG