Putting Into Operation - hajdu Z30E Instructions De Montage Et D'utilisation

the connection to one phase, which
can also be seen on the cover of the
fitting house. The bundle wire has to
be discharged against tightening with
the help of a bent clamp after electric
connection.
E
5.5 , The connecting wire has to

be discharged with fixing the carriage
at lead-In after electric connection.
EK-1
The connecting wire has to be
placed between the two parts of the
bent clamp, then it has to be fixed to
the cable sheath base with the fixing
screws.
Touch protection
appliance: I.
The covers closing electric accessories
provide suitable protection against
accidental touch of active electric
parts being under
operation.
Please, connect the appliance to the
electric network according to the
connection diagram located both on
the bottom sheet and in the usage
manual of the appliance. IT IS AT THE
RISK OF DEATH AND THEREFORE IT IS
FORBIDDEN to install and operate the
appliance without professional
connection of touch protection wire!
It is proposed to apply touch protection
relay in the electric network of the
establishment to operate the appliance
adequately.
5.6 It is forbidden to operate the hot
water tank without any protective
earthing. The protective earthing has
to comply with the instructions of the
Hungarian Standard MSZ 2364.
All manuals and user guides at all-guides.com
class of
power during
EN

6. PUTTING INTO OPERATION

After installation, the hot water
tank can be put into operation.
Please turn
technician
operation at the first operation.
6.1 Open the closing valve (Figure
2., item No. 1) and the hot water
faucet but keep the cold water
faucet closed. The water flowing in
fills up the water tank. In order to
flush the unit, please, keep the
water flowing for some minutes and
then close it.
the
6.2 With the help of the main
switch, connect the water tank to
the electric system. Set the desired
temperature with the help of the
temperature
During heating, the indicator is lit
on.
6.3 During
expanding water may leak through
the water outlet of the combined
safety valve, therefore this pipe
has to be kept opened toward the
air space.
6.4 At the end of heating time,
when the temperature of the water
reaches
temperature controller switches off
automatically. After draining appr.
15% of
controller has to switch the heating
on automatically. If the controller is
not switching
automatically, please call the repair
service.
15
to a professional
to control
controlling
heating time,
the value set,
water quantity,
on the
correct
button.
the
the
the
heating