Initial Operation - ULTIMATE SPEED UMK 10 A1 Traduction Du Mode D'emploi D'origine

tended;
- you are repairing or servicing the
appliance;
- the mains lead is damaged;
- foreign particles have got in or ab-
normal sounds are heard.
• Only use accessories supplied and rec-
ommended by the manufacturer.
• Do not try to repair the appliance your-
self.
Caution: How to avoid accidents
and injuries caused by electric
shock:
Electrical safety:
• Do not operate the appliance if its
On/Off switch cannot be set. Have
damaged switches replaced.
• Do not use the cable to carry the appli-
ance. Do not pull the cable to unplug
from the mains. Keep the cable away
from heat, oil and sharp edges.
• Attach the power cord to the vehicle's
cigarette lighter only.
• Take heed of the cigarette lighter op-
erating instructions provided by the
manufacturer of your car.
• Immediately unplug the appliance from
the cigarette lighter if the cable is dam-
aged.
• The power cord of this appliance can-
not be replaced. If it damaged, the
appliance must be scrapped.

Initial Operation

Set up the device on a level,
non-combustible surface. The
vent holes must not be cov-
ered. Do not operate the de-
vice in a dusty environment.
There is a risk of fire and the
device could be damaged.
All manuals and user guides at all-guides.com
For an inflatable item with counter-
pressure (e.g. partially filled tyres):
switch on the device before con-
necting the connection valve to the
tyre.
Depending on the inflatable item,
the connection valve (7) can be
used directly or in conjunction with
the valve adapters (10) included in
the delivery contents.
Connecting the device to the ciga-
rette lighter:
Ensure that the cigarette lighter
socket of your vehicle is adequately
fused.
1. Ensure that the device is switched off:
on/off switch (
Plug the cigarette lighter plug (
into the 12 V cigarette lighter socket.
Connecting the connection valve (7):
2. Open the connection valve (7):
tensioning lever (8) vertical up-
wards (position
3. Connection without valve adapt-
er (10):
- Plug the open connection
valve (7) into the valve on the
inflatable item (remove the
valve cap on the inflatable
item beforehand if neces-
sary).
- Hold down the connection
valve and close it: push the
tensioning lever (8) towards
the connection valve (position
‚ ).
4. Connection with valve adapter
(10):
- Push the respective valve
GB
6) in "0" position.
5)

).
23