Operating - Dirt Devil Infinity V12 Mode D'emploi

All manuals and user guides at all-guides.com
02_Infinity_gb.book Seite 29 Donnerstag, 29. Januar 2009 12:56 12

3 Operating

3 Operating
3.1 Vacuuming
4
1
2
1
.
WARNING:
Check the cylinder vacuum cleaner and the power cable
before each use. A damaged appliance must never be
used. There is a risk of injury.
ATTENTION:
Only use the cylinder vacuum cleaner if all filters are
correctly in place and once you have ensured that no
openings are blocked The filters must be intact and dry.
Non-compliance can damage the cylinder vacuum cleaner.
1. Push on the desired nozzle,
nozzles (accessories)".
2. Remove the cable, by holding the plug, until the yellow
mark is reached (Fig. 11/1).
WARNING:
If the red mark (Fig. 11/2) is visible, use the cable retract
button (Fig. 11/3) to draw in the cable again up to the
3
yellow mark (Fig. 11/1). Otherwise the cable can break
off. There is a risk of electric shock.
Fig. 11
3. Switch on the cylinder vacuum cleaner using the on/off
switch (Fig. 11/4).
4. Adjust the carpet/hard floor switch (Fig. 12) depending
on the type of flooring:
- Hard floor (Fig. 12/A)
A
Laminate flooring, tiles, PVC flooring, etc.
- Carpet (Fig. 12/B)
Long and short pile carpets, runners, etc.
B
5. To vacuum, pull the cylinder vacuum cleaner behind
Fig. 12
you like a sledge. Observe the recommendations of the
flooring manufacturer.
NOTE:
You can quickly reduce the suction power with the
secondary air controller (Fig. 13/1), e. g. to release
curtains that have been sucked in.
NOTE:
The cylinder vacuum cleaner has an overheating
protection device. It will switch off automatically if
Fig. 13
overheated (e. g. due to blocked nozzles or over-full dust
container). If this happens, then turn off the appliance
and remove the plug. Remove the cause of overheating.
Wait approx. 45 min. You can use the cylinder vacuum
cleaner again once it has cooled down.
Chapter 2.3, "Using other
29