Publicité
Les langues disponibles
Les langues disponibles
Speaker outputs
The disco set must be turned off during connection work.
The line towards the speakers must be a bifilar cable. Insulate all connecting terminals. Ensure
there are no sharp edges which could damage the cables.
Only use the included speakers or speakers with a sufficiently high loading capacity (see
„Technical Data").
Connect the speakers directly with the amplifier.
Do not use headphone adapters or distribution boxes. If you are unsure about anything, please
contact a specialist.
Make sure that all speakers have the correct polarity, i.e. the plus and minus signs must match.
This amplifier has been designed for a speaker impedance of 4-16 Ohm on each channel. Only
connect one speaker to each output.
Connect the speaker outputs POWER OUT (5) to the speaker connection clamps.
•
Connect the CH1 connection at the amplifier to the left speaker and the CH2 connection to the right one.
•
Now connect the red connection market „+" to the red connection at the speaker marked (+) .
•
Now connect the black connection market „-" to the black connection at the speaker marked (-) .
Mains Connection
The mains outlets to which the amplifier is connected must be easily accessible to quickly
separate it from the mains voltage in case of an error.
The disco set and all connected devices must be turned off when connecting the voltage
supply.
Make sure that all electrical connections and connection cables between the different devices
and any extension cables comply with the regulations and the operating instructions.
•
Plug the power plug into a wall socket.
•
The POWER switch (1) is used to switch the disco set on and off.
Position „O": Device is switched off.
Position „I": Device is turned on.
24
All manuals and user guides at all-guides.com
Publicité
Chapitres
Dépannage
