Before First Use - SilverCrest SKMK 1000 A1 Mode D'emploi

All manuals and user guides at all-guides.com

Before first use

WARNING
► Hot steam escapes from the steam outlet openings 2 of the appliance lid!
There is a risk of scalding!
► Never open the appliance lid while brewing is in progress! Bursts of hot
steam may be released or hot water may spray out . There is a risk of
scalding!
► The hotplate 7 under the coffee pot 6 is heated strongly during the
brewing/keeping warm process . There is a risk of burns!
CAUTION – PROPERTY DAMAGE!
► Never fill the water tank 0 to more than the total amount required for
10 cups (MAX marking) .
► There is a small hole 3 on the back of the appliance . This is a water over-
flow that prevents too much water from being poured into the appliance . If
the water level exceeds the MAX mark, the water will escape through the
water overflow 3 onto the worktop .
► If the appliance is moved with a full water tank 0 (10 cups of water),
water may run out through the water overflow 3 .
► Never fill the water tank 0 with less than 2 cups of water . Use the fill level
indicator 4 on the water tank 0 for reference .
1) Place the appliance on a level and heat-resistant surface .
2) Rinse the coffee pot 6 thoroughly with water and place it in the appliance .
3) Open the appliance lid by pulling it upwards by the handle 1 .
4) Remove the filter basket q from the filter basket holder 9 .
5) Rinse the filter basket q in fresh water and replace it in the appliance .
6) Fill the water tank 0 with water for 10 cups .
7) Close the appliance lid .
8) Insert the plug into a mains power socket .
9) Press the
The brewing process begins .
10) Wait until the brewing process is completed and press the
again to turn off the appliance .
SKMK 1000 A1
button 5 . Wait a moment . The button 5 lights up .
button 5
GB │ IE │
23 ■