Publicité
Les langues disponibles
Les langues disponibles
7
OPERATION
GB
7.3 OPERATING PROCEDURE
1.
Under no circumstances should the engine be started without the operator seated on the tractor.
2.
Do not operate tractor or attachments with loose, damaged or missing components. Whenever
possible mow when grass is dry
3.
First mow in a test area to become thoroughly familiar with the operation of the tractor and control
levers.
Note:
To prevent damage to the reel and bottom blade never operate the reels when they are not
cutting grass. Excessive friction and heat will develop between the bottom blade and reel
and damage the cutting edge.
4.
Study the area to determine the best and safest operating procedure. Consider the height of the
grass, type of terrain, and condition of the surface. Each condition will require certain adjustments
or precautions.
5.
Never direct discharge of material toward bystanders, nor allow anyone near the machine while in
operation. The owner/operator is responsible for injuries inflicted to bystanders and/or damage to their
property.
6.
Use discretion when mowing near gravel areas (roadway, parking areas, cart paths, etc.). Stones
discharged from the implement may cause serious injuries to bystanders and/or damage the
equipment.
7.
Disengage the drive motors and raise the implements when crossing paths or roads. Look out for
traffic.
8.
Stop and inspect the equipment for damage immediately after striking an obstruction or if the
machine begins to vibrate abnormally. Have the equipment repaired before resuming operation.
GB-16
All manuals and user guides at all-guides.com
CAUTION
To help prevent injury, always wear safety
glasses, leather work shoes or boots, a
hard hat and ear protection.
CAUTION
Pick up all debris you can find before
mowing. Enter a new area cautiously
Always operate at speeds that allow you to
have complete control of the tractor
WARNING
Before you clean, adjust, or repair this
equipment, always disengage all drives,
lower implements to the ground, engage
parking brake, stop engine and remove
key from ignition switch to prevent injuries.
JACOBSEN G-PLEX III Series: DN & DP
SAFETY AND OPERATORS MANUAL
Publicité
Chapitres
